DC distribution panel

3U Horizontal Breaker Rack PDU, 19-inch, 110–250 V, Grey

Quick Answer3U Horizontal Breaker Rack PDU, 19-inch, ⁦110–250⁩ V, Grey — an IDCPDU DC distribution panel for data-centre and equipment-room racks.

⁦110–250⁩ V wide input — One build covers 120 V and 230 V sites and rides out a brownout instead of dropping the load.
Breaker ahead of the outlets — A fault trips inside the strip, not at the upstream panel — the rest of the row keeps serving traffic.
Hard-wired terminal block — There is no inlet plug to work loose or heat up — the feed lands on terminals sized for the strip's full current.
Runs below zero — Tested from sub-zero ambient upward, so cold shelters and unheated halls are inside the envelope, not outside it.

Tel: +86-574-63783045 · ricky@idcpdu.com

3U horizontal chassis with integrated breaker
⁦110–250⁩ V input, copper bar connection
Outlet layout built to your drawing
A 465 mm horizontal shell that takes the socket modules you specify — C13, C19, national sockets or a mix — so one chassis covers several country builds without a new tooling set.
Input is a copper bar with an integrated breaker, which keeps the internal temperature low at high outlet counts; the grey powder coat matches light-coloured racks and wall cabinets.
Used for OEM builds, country-specific socket combinations and projects where the outlet mix changes between orders.
Tell us the outlet list and we return a layout drawing within 30 minutes and a quotation within 1 hour.

Frequently Asked Questions

How many outlets fit in a 3U chassis?

It depends on the socket type: typically ⁦10–14⁩ national sockets or ⁦12–16⁩ C13 modules. Send the list and we confirm the exact count in the layout drawing.

Which socket standards can be fitted?

IEC C13 and C19, British BS 1363, German Schuko, Swiss SEV 1011, US NEMA and Chinese GB — all on the same 465 mm chassis.

Is the breaker single or two-pole?

Single-pole by default; two-pole is available when the supply is 230 V with a switched neutral requirement.

Can this be used as an ATS or switched PDU?

No — it is a passive distribution chassis with a breaker. ATS and per-outlet switching are separate product families.

What about the black and 9U versions?

Same family: the 9U version has a 531 mm body for taller cabinets, and the black version uses the same 465 mm shell.

What is the minimum order quantity?

One unit for sample approval; production quantities run from 10 pieces with ⁦7–15⁩ working days after drawing approval.

Rack standard	19-inch rack, 3U
Installation	Horizontal
Mounting length	465 mm
Body dimensions (W×H)	60 × 85 mm
Input voltage	⁦110–250⁩ V AC, 50/60 Hz
Phase	Single-phase
Input connection	Hard-wired terminal block
Main breaker	Yes
Master switch	No
Housing	Cold-rolled steel, grey powder coat
Operating temperature	-⁦10–45⁩ °C
Relative humidity	⁦0–90⁩% RH, non-condensing
Included accessories	M6×16 screws
Certification	CE / EMC; built under ISO 9001

3U Horizontal Breaker Rack PDU, 19-inch, 110–250 V, Grey

Product Description

Product Specifications

Product documents

Support & Contact

Feedback

Frequently Asked Questions

Related Products

9U Horizontal Breaker Rack PDU, 19-inch, 110–250 V, Grey

Horizontal Breaker Rack PDU, 19-inch, 110–250 V, Black